[MUSIC]
The battery in your Transit isn't located in the engine compartment like other vehicles.
It's located inside the vehicle and under the driver's seat.
And there are a few things you'll need to know about it.
First, let's talk about how to jump your battery if it dies.
Open the engine hood by pulling on the hood
release located under the storage bin next to the driver's side door, here.
The battery jump box is located on the driver's side of the engine compartment.
Lift up the red access panel to expose the positive battery post, and
attach the positive end of your jumper cable to it.
Now, connect the negative end to the ground,
located on the inside of the driver's side fender, here.
Okay, now let's talk about how to replace the 12-volt battery.
It's located inside the cabin, under the driver's seat.
First, you'll need to move the driver's seat all the way back.
Next, open the two plastic screw covers on each side of the front of the seat,
by inserting your finger into the tabs and pulling them open, they'll swing inward.
Now remove the two rail stop bolts using a T-40 type Torx bit, here.
With the arm rests folded up, slide the seat all the way forward.
To access the battery compartment on Transit Wagon models,
first remove the protective plastic molding, by pulling up on the tabs, and
sliding it towards you.
Next, lift the fabric covered trim by pulling up on the tabs, and tuck, or
fold it to keep it out of your way.
You'll need to remove the rear metal battery cover by unscrewing two fastening
bolts, here and here.
Next, unfasten the two electrical cords,
by unclipping them from the fasteners like this, and remove the bar.
To remove the battery cover,
first remove the small panel that covers the negative battery cable.
Once the panel is off, you'll need to loosen the nuts on the negative
pull clamps and remove the cable from the battery.
Next, unsnap the tab in the front, here.
Then, slide the lid forward until the two additional front-side tabs
come unattached.
Now, lift and pull the cover to remove it.
Then, loosen the nuts on the positive pull clamps and
remove the clamps from the battery.
Be sure to use the lift handles provided when removing the batteries,
since they are very heavy.
You may have a single battery. To replace it with the cover panel off, loosen and
remove the negative pull clamp.
Then rotate the battery and remove the positive pull clamp.
To install the new battery, just follow the same directions, but
in the reverse order.
Any questions, go to FordOwner.com.
[MUSIC]
For more infomation >> Perfect Placement -- Motor Trade Jobs - Duration: 2:52. 
For more infomation >> Perfect Placement -- Motor Trade Jobs - Duration: 2:17. 
For more infomation >> Perfect Placement -- Motor Trade Jobs - Duration: 1:45. 
For more infomation >> Perfect Placement -- Motor Trade Jobs - Duration: 2:04. 
For more infomation >> Perfect Placement -- Motor Trade Jobs - Duration: 1:57. 
For more infomation >> Perfect Placement -- Motor Trade Jobs - Duration: 2:03. 
For more infomation >> TNN MOTOR MADNESS Great LAkes Car Wars demo derby - Duration: 29:58. 
For more infomation >> Perfect Placement -- Motor Trade Jobs - Duration: 2:11. 
Không có nhận xét nào:
Đăng nhận xét