Hi all welcome again to a new vlog on my channel.
Today we are going to do something funny, but for now I will not tell you what!
In a minute I will show you what we need.
You will need about 5 meter of thin copper wire...
Something round with about a 2 cm diameter. in my case a peace of PVC pipe...
Some pliers...
Battery's (3 volt)... The one I used in my last Tesla coil vlog will do.
And a knife.
We will first need to wind 20 winding's of copper wire around the PVC pipe.
Make sure that you leave some wire sticking out!
Lets start winding the coil.
One...
two, three, four.......
....
..... nineteen, twenty.
Make sure you leave enough over when cutting the wire!
Now carefully remove the winding's from the PVC pipe.
It does not matter if the winding's are all over each other.
Just remove it.
And when it has been removed, wrap one of the wires around the coil.
Do two to three wraps so the coil wires will stay in position.
Do the same on the other side!
The base is almost done now.
Now you need to cut one of the wires so that about 3 cm is leftover.
Leave the other wire as is.
Now you need to remove the isolation from the copper wire.
Remove it for about 1 cm.
Make sure you do this all the way around!
Next we need to make a small loop at the end of the wire. Do this to the part where we removed the isolation.
And bent the wire with the loop up like so.
Now we need another peace of wire!
About 15 cm will do.
Remove again about 1 cm of isolation from the copper wire...
And make a small loop at the part where the isolation has been removed.
Now attache the wire to the main coil like so.
Make sure it has the same height as the opposite one.!
Also make sure that it's exactly opposite of the other one that we made earlier.
Two to three wraps will do.
The bottom part is done. Now we need to make the top part!
We are going to make another coil with 20 wraps!
This time with a smaller diameter. You can use a 1.5 volt battery for this!
Make sure you leave some wire sticking out.
One ...
...
... Twenty.
Cut the wire at the end. Leave about 3 cm over.
Carefully remove the coil from the battery...
and wrap the wire end 2 to 3 times through the coil (like we did with the big coil)
Do the same to the other side!
Make sure that both sticking out wires are straight!
Now you need to remove the isolation at the end of the copper wire!
Make sure that you hold the coil like so, and ONLY remove the isolation at the top part from the wire!
When done, keep the coil facing up, and remove the top isolation from the other wire.
Carefully feed one of the wires through one of the loops that we made on the main coil...
Feed the other wire through the other loop from the main coil.
Done. Did you guess what we are making?
No?
It's an electric motor!
Now lets connect the battery's!
The same battery's as I used in my Tesla coil build.
See my previous video.
Now give it a very light push to start it up!
And yes. It's working!
Oops. Let's try again.
Yes... It's running!
Bye bye. See you at the next vlog.
The next week I will be uploading more video's in one week. So stay tuned!
Không có nhận xét nào:
Đăng nhận xét